[. . . ] replace worn or damaged blades and screws in sets to preserve balance. 6) Before mowing, attach the discharge opening guards (grasscatcher or stone-guard). Safety devices, such as the stone-guard and/or grass-catcher, in place. 12) Do not change the engine governor settings or overspeed the engine. [. . . ] D) MAINTENANCE AND STORAGE 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. 2) Never store the equipment with fuel in the tank inside a building where vapour may reach a flame or a spark or a source of extreme heat. 4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area free of grass, leaves, or excessive grease. 5) Check the stone-guard and grass-catcher frequently for wear and deterioration. 6) If the fuel tank has to be drained, this should be done outdoors and when the engine is cool. All operations on the blade (dismantling, sharpening, balancing, remounting and/or replacing) require a certain familiarity and special tools. 9) For reasons of safety, do not use the equipment with worn or damaged parts. Parts that are not of the same quality can damage the equipment and be dangerous for your safety. C) OPERATION 1) Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. 5) Walk, never run and do not allow yourself to be pulled along by the lawnmower. 10) Stop the blade if the lawnmower has to be tilted for transportation when crossing surfaces other than grass, and when transporting the lawnmower to and from the area to be mowed. The speed changer (if fitted) is controlled by moving the lever to one of the four positions, marked as: 1 2 3 - 4 4. 1 All operations on the blade should be carried out at a specialized centre. 2 In power-driven models: • adjust the tension of the belt with the nut (1) to get the right measurement (6 mm). € turn the adjusting nut (2) so that the wire (3) is slightly loose and the lever (4) is idle. 5 The move from one speed to another must be made with the engine running and drive engaged. IMPORTANT - Do not touch the speed changer when the engine is stopped. 1 Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. Should you have any doubts or problems, do not hesitate to contact your nearest Service Centre or your Dealer. Keerake registrit (2) astmeliselt vastupäeva (nii, et see pikeneks) kuni juhthoob (1) ei ulatu hästi asendisse«4»; seejärel keerake registrit umbes pool pööret päripäeva, et saavutada liikumiskiiruse optimaalne reguleerimine ja nelja kiiruse korrektne sisseviimine juhthoovaga (1). GB Service, spare parts and guarantee Maintenance and repair The maintenance and repair of modern machines, as well as all safety devices, require qualified technical training and a special workshop equipped with special tools and testing devices. All work not described in this Instruction Manual may be done only by a properly qualified workshop or authorised service centre. [. . . ] All repairs covered by the guarantee must be performed by a DOLMAR service centre. Responsibility On tools with engines by Briggs&Stratton, Honda, Tecumseh or Robin Subaru, the engine manufacturer or their authorised service centre is responsible for the engine only. DOLMAR is responsible for the rest of the tool (excluding the engine). This does not apply to electrical generators and all other tools or equipment not containing engines of the above brands. [. . . ]